Chauvet Tiger DMX 60 Betreibershandbuch Seite 77

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 206
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 76
1. Setting up the console - Page 109
Pearl 2008 Manual - 16th July 2007
CHAPTER ONE
1. Setting up the console
This chapter contains: Connecting mains power; connecting DMX lines;
connecting MIDI devices; connecting audio; the disk drive; other back
panel connections and controls; desk modes.
1.1 Connecting up
1.1.1 Connecting mains power
Important! Before connecting the mains power to the Pearl you must
check if the Pearl has a voltage selector switch next to the mains
socket; if it does, make sure it is set to match your mains supply. It
can be set to 120V or 220V.
If the Pearl does not have a voltage selector switch you can safely
connect it to any voltage from 80 to 260V.
If you connect mains power with the switch set incorrectly, you will
probably blow up the power supply unit. If this happens you will need
to shamefacedly return the console to Avolites for repair.
1.1.2 Connecting DMX lines
The Pearl can output DMX down 4 separate lines. When you patch a
dimmer or fixture you can tell the Pearl which DMX line it is on. The
lines are identified by the letters A,B,C,D. Normally A comes out of
output 1, B comes from 2, C from 3, and D from 4, but just to add to
the fun you can swap this round if you want (see Patching, section 2).
The 4 DMX outputs come out of the 5 pin XLR sockets on the back of
the console. The Pearl 2004 onwards have four separate sockets. The
Pearl 2000 had only two sockets with two DMX lines on each, so you
need splitter cables to access all four lines on the Pearl 2000. They are
wired like this:
Pearl 2004 Pearl 2000
DMX line
Socket Pin numbers Socket Pin numbers
1 (normally A) 1 & 3 2=Data -
3=Data +
1 & 3 2=Data -
3=Data +
2 (normally B) 2 & 4 2=Data -
3=Data +
2 & 4 2=Data -
3=Data +
3 (normally C) 3 2=Data -
3=Data +
1 & 3 4=Data -
5=Data +
4 (normally D) 4 2=Data -
3=Data +
2 & 4 4=Data -
5=Data +
The sockets marked “1 & 3” and “2 & 4” on the newer Pearls have pins
4 and 5 connected to the other DMX lines as with the Pearl 2000,
making the newer consoles pin-compatible with the Pearl 2000 if
replacing one console with the other.
Seitenansicht 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare