Chauvet Tiger DMX 60 Betreibershandbuch PDF herunterladen (Seite 174)

Page 206 - 13. Other features

Pearl 2008 Manual - 16th July 2007

message “Failed” appears or the system halts for a long time

before 100% is reached, the disk is probably faulty. Download the

software again onto another disk and try again.

8> Press 1 [Wipeall and start system] followed by Enter to restart the

main program. Do not use A [Start system] as the new software

may not be compatible with the data stored internally in the

memory.

• The show in the Pearl will be lost during the upgrade. Save the show

before upgrading, and reload it afterwards, if you want to keep it.

• You can also enter AVOS mode by holding down the 21 and 30 Flash

buttons while powering up the Pearl.

13.1.7 Installing new fixture personalities

You can update the internal fixture personalities by downloading the

latest Pearl 2008 personality files from the Avolites website, then using

the “Sync Fixtures” option on the USB Stick Options menu. See section

13.1.2 on page 201.

Copying personalities can take a long time, up to 60 minutes. You can

patch fixtures from your external USB disk if you are short of time.

13.1.8 Troubleshooting an Invalid License

If hardware in the console is replaced or a serious hardware problem

happens, the console may display “Program panel keys not responding

due to invalid license”. At this point you have two choices, you may

start the console in unlicensed mode which will allow you to run a

previously programmed show, but not change anything, or you may

start in AVOS mode and relicense the console. (You will need the AVOS

software on disk to relicense, which you can get from the Avolites

website). Please see section

13.1.5 for details of how to license the

console.

13.1.9 Hardware WIPEALL mode

You can do a complete factory reset by fitting a link on the board. You

should obviously save any show data that you want to keep. It may

also be advisable to have a backup of the system software (AVOS

option D) before you do this… just in case.

1> Disconnect the Pearl from the mains.

2> Undo the half-turn fasteners on the rear edge of the console, and

lift the fader section of the console.

3> Fit the Wipeall link. On Borris 3 motherboards this is at the

bottom right of the board near the 4-digit display. On older

motherboards it is located on the main PCB near the large square

processor. It’s labelled on the PCB legend. A link is provided fitted

to one of the pins. Fit the link so it connects the two pins.

4> Close the console (don’t fasten it), then turn on the power.

5> The console will power up in the AVOS menu. Select option A

“Start the System”. (do not select any other option when the

Wipeall link is fitted).

6> Turn off the Pearl, open it and remove the Wipeall link (fit to one

of the pins only). If you forget this, the console will do a Wipeall

every time you turn it on!

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare

Chauvet Tiger DMX 60 Betreibershandbuch Seite 174

Kommentare zu diesen Handbüchern