Chauvet Tiger DMX 60 Betreibershandbuch PDF herunterladen (Seite 163)

12. Setup - Page 195

Pearl 2008 Manual - 16th July 2007

CHAPTER TWELVE

12. Setup

This chapter contains: The user settings menu; Wipe modes; Disk

functions

The Pearl is very easy to customise to your preferred way of working.

The main options are contained in the “User settings menu”.

12.1 User Settings

12.1.1 The User Settings menu

This menu is obtained by holding down the AVO button and pressing C

[User Settings]. You can also turn the key to System mode and press C

[User Settings].

You select the option to change using the cursor up/down buttons, and

make the changes using the left/right buttons.

The options are:

1. Normal Run / Take Over - Sets the Run mode of the Pearl. This

option can also be set by pressing Softkey A while in Run mode.

See page

183 for details of Run mode.

2. Rec by Fixture / Rec by channel - Sets the recording mode of the

Pearl. If set to “by Fixture”, if any attributes of a fixture are

changed, all attributes are recorded. If set to “by channel”, only

changed attributes are recorded. See page

147 for details of how

this works. This option can also be set by holding the Avo button

and pressing Softkey B.

3. Speed=Seconds / BPM - Allows you to set whether chase speed is

displayed in Seconds or Beats Per Minute (tempo).

4. Autoconnect Yes / No - Allows you to turn Chase autoconnect on

or off. If on, the controls are automatically connected to the most

recently turned on chase. If off, you have to connect the chase

manually using the Connect button.

5. Palette page Off / On - When set to on, 30 different palettes are

available from the flash buttons on each fixture page (1-30 on

Page 0--, 31-60 on Page 1--, 61-90 on Page 2-- and 91-120 on

Page 3--). When set to Off, palettes 1-30 are on the flash buttons

for all fixture pages.

6. Q palette Off / On - Enables the quick palette function which allows

you to apply a palette to all fixtures if no fixtures are selected

7. G-Tablet / Remote Control / DSR-20 Remote - Specifies what

device is connected to the serial port

8. DMX Chans = xxx - Sets the maximum number of DMX channels to

transmit. If your rig does not use all 512 channels, you can

improve the DMX refresh rate by reducing this number to the

maximum of your rig.

9. Fader ON > x (vv) - Sets the level of the fader at which LTP

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare

Chauvet Tiger DMX 60 Betreibershandbuch Seite 163

Kommentare zu diesen Handbüchern