Chauvet Tiger DMX 60 Betreibershandbuch PDF herunterladen (Seite 151)

10. Running the show - Page 183

Pearl 2008 Manual - 16th July 2007

CHAPTER TEN

10. Running the show

This chapter contains: Run modes, channel mimics, master faders,

manual control during a show

10.1 Playback

10.1.1 Run modes

When you finish programming, back up the console to disk before you

start the show (see page

197). Then turn the key to Run mode to make

sure you can’t accidentally change anything.

When you are running a show, there are two modes available to you,

normal Run mode, where you can turn on anything you have

programmed but can’t control anything manually, and Takeover run

mode which allows you to take manual control if you want. The mode

also affects how the Swop and Flash buttons on the console operate.

There is also “2 preset mode” which you have to enable in the User

Settings menu, see section

10.2.

You can select the mode by pressing A [Toggle mode]. The mode is

shown on the top line of the display.

• Normal Run mode: the Flash and Swop buttons on the handles

and playbacks work as flash buttons. The “Flash” button adds the

function into anything else which is on. The “Swop” button turns

on the function, but turns off everything else while the button is

held down. The programmer is cleared and you can’t manually

control any LTP channels. You can control HTP channels using the

preset faders.

• Takeover run mode: the Swop buttons on the handles allow you

to select dimmers or fixtures for manual control. This lets you add

to or change your programming in real time during the show. The

Flash buttons on the handles recall palette values (but unless you

are used to the Pearl, it is easier to use the dedicated Palette

buttons). The faders still control the intensity of the dimmers and

fixtures. The Flash and Swop buttons on the playbacks are

disabled.

10.1.2 Master faders

In the bottom left hand corner of the console are the Master Faders.

These allow overall intensity control of the whole console.

• The Add/Flash and Swop masters control the intensity of the Flash and

Swop buttons on the playbacks. This allows you to flash the playbacks

to a certain level. It also allows you to disable the Flash buttons by

setting the master at 0. (If you turn the Swop master to 0 you will get

a blackout if you press a Swop button).

• The Preset Master controls the overall intensity of any channels turned

on in the Preset faders.

• The Grand Master controls the intensity of all output from the console.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare

Chauvet Tiger DMX 60 Betreibershandbuch Seite 151

Kommentare zu diesen Handbüchern