Chauvet Tiger DMX 60 Betreibershandbuch Seite 153

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 206
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 152
10. Running the show - Page 185
Pearl 2008 Manual - 16th July 2007
10.2 Options
10.2.1 Two-preset mode
You can use the top and bottom preset faders to control dimmers
patched on the 1-30 faders in a standard “two preset” mode, using the
A and B Masters as preset masters. In this mode, fader 31 controls the
same dimmer as fader 1, fader 32 controls the same as fader 2, and so
on. This allows you to set up two different lighting states and fade
between them using the A and B masters, as you would on a basic
lighting desk.
To enable Two preset mode, set User Setting 1 to “2-preset”. (Hold
AVO and press Softkey C to get the user settings).
In this mode, anything patched to the top faders 31-60 is not
accessible using the faders, however programmed memories and
chases will play back as if in Normal Run mode. The Playback Master
fader is used as the B Master in this mode and does not control
Playback level. All playbacks will run at full level.
Tiger: 2-preset mode cannot be used on the Pearl Tiger.
10.2.2 Temporarily locking the console
You can temporarily lock the console by typing a 4 digit code then
pressing C [Lock Desk], then Enter. All the controls on the panel will be
disabled. Enter the code again to unlock the console.
This is useful to prevent passers-by or sound engineers tampering with
the console if you need to leave it unattended; it is not secure as you
can simply reset or re-power the console to remove the lock.
10.2.3 Channel mimics
If you are in normal Run mode, the LEDs on each handle mimic the
intensity of the fixture or dimmer controlled by that handle (i.e. they
are lit if it is turned on).
If you are in Takeover Run mode (or Program mode), you can choose
between “Mimic” mode, or “Fixture” mode where the LEDs show you
which fixtures are selected for manual control.
You select the mode by holding down the Avo button and pressing
Softkey A. The button shows “Preset LEDs = Fixtures” (or mimics)
depending on the mode. You can also change this mode using the
Graphics Tablet.
Seitenansicht 152
1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 205 206

Kommentare zu diesen Handbüchern

Keine Kommentare