
1. Before You Begin
MotionOrb™ User Manual Rev. 1 Page 7 of 96
Glance
Use on Dimmer
Auto Program
Outdoor Use
Auto-Ranging Power Supply
Sound-Activated
Replaceable Fuse
DMX
User-Serviceable
Master/Slave
These notes include important information about the mounting, use, and maintenance of this
product. Read these notes before using the product.
• Always connect the product to a grounded circuit.
• Make sure the power cord is not crimped or damaged.
• Always disconnect the product from the power source before cleaning it or replacing the
fuse.
• Never disconnect the product from the power source by pulling or tugging on the cord.
• Always secure the product with a safety cable when mounting it overhead.
• Keep the product away from flammable materials.
• The product is not intended for permanent installation.
• Use the product indoors only.
• Do not expose the product to rain or moisture.
• Make sure that the power source voltage is within the range stated on the label or on the
rear panel of the product.
• Never connect the product to a dimmer or a rheostat.
• Always replace the fuse with another fuse of the same type and rating.
• Always install the product in a location with adequate ventilation, and leave at least
20 in (50 cm) between the product and adjacent surfaces.
• Do not block the ventilations lots on the product’s housing.
• Do not operate the product in an ambient temperature higher than 104 °F (40 °C).
• Do not carry the MotionOrb™ by the orb strings.
• In the event of a serious operating problem, stop using the product immediately.
• Never try to repair the product. Repairs carried out by untrained people can lead to damage
or malfunction.
• If repairs are required, contact the nearest authorized technical assistance center.
• Keep this User Manual for future reference. If the product is sold, be sure to give this
manual to the next owner.
Kommentare zu diesen Handbüchern