Chauvet Techno Strobe 168 Bedienungsanleitung PDF herunterladen (Seite 7)

Techno Strobe™ 168 User Manual (Rev. 2) Page 7 of 16

3. SETUP

AC Power

The Techno Strobe™ 168 has an auto-

ranging power supply and it can work with an

input voltage range of 100~240 VAC, 50/60 Hz.

To determine the product’s power requirements (circuit breaker, power outlet, and

wiring), use the current value listed on the label affixed to the product’s back panel, or

refer to the product’s specifications chart. The listed current rating indicates the

product’s average current draw under normal conditions.

Always connect the product to a protected circuit (circuit

breaker or fuse). Make

sure the product has

an appropriate electrical ground to avoid the risk of

electrocution or fire.

Never connect the product to

a rheostat (variable resistor) or dimmer circuit, even

if the rheostat or dimmer channel serves only as a 0~100% switch.

Fuse

Replacement

Disconnect the product from power before replacing the fuse.

1. Disconnect the product from power.

2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

3. Pry the fuse holder out of the housing.

4. Remove the blown fuse from the holder.

5. Replace with a fuse of the exact same type and rating.

6. Insert the fuse holder back in place and reconnect power.

A spare fuse is not included; however, the safety cap has room for a spare.

Always replace a blown fuse with another of the same type and rating.

Installed fuse

(held by plastic clip)

Spare fuse holder

(inside safety cap)

Safety cap

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

Chauvet Techno Strobe 168 Bedienungsanleitung Seite 7