Chauvet Techno Strobe 168 Bedienungsanleitung PDF herunterladen (Seite 13)

Techno Strobe™ 168 User Manual (Rev. 2) Page 13 of 16

Master/Slave

Mode

The Master/Slave mode allows a single Techno Strobe™ 168 unit (the “master”) to

control the actions of one or more Techno Strobe™ 168

units (the “slaves”) without the

need of a DMX controller. The master unit will be set to operate in Manual or Sound-

Active mode, while the slave units will be set to the same DMX starting address

. Once

set and connected, the slave units will operate in unison with the master unit.

Configure the units as indicated below.

Slave units:

1. Set the DMX address to 1.

2. Connect the DMX input of the subsequent slave units to the DMX output of the

previous slave unit.

3. Finish setting and connecting all the slave units.

4. Connect the DMX input of the first slave unit to the DMX output of the master unit.

Master unit:

1. Set the master unit to operate in Manual or Sound-Active mode.

2. Make the master unit the first unit in the DMX daisy chain.

• Configure

all the slave units before connecting the master unit to the DMX

daisy chain.

•

Never connect a DMX controller to a DMX string configured for Master/Slave

operation because the controller may

interfere with the signals from the

master unit.

• Do not connect more than 31 slave units to the master unit.

1 2 ... 8 9 10 11 12 13 14 15 16

Keine Kommentare

Chauvet Techno Strobe 168 Bedienungsanleitung Seite 13