Chauvet Q-Spot 360-LED Bedienungsanleitung PDF herunterladen (Seite 9)

Setup

April 7, 2010 -5- Q-Spot 260-LED User Manual Rev. 01d

3. Setup

AC Power

The Q-Spot 260-LED has an auto-ranging power supply that can work with an input

voltage range of 100~240 VAC, 50/60 Hz.

Make sure that you are connecting this product to the proper

voltage, as per the

specifications in this guide, the product’s user manual or on the product’s sticker.

Always connect the Q-Spot 260-LED to a protected circuit with an appropriate

electrical ground to avoid the risk of electrocution or fire.

To determine the power requirements for the Q-Spot 260-LED see the label affixed to

the side of the fixture. Alternatively, you may refer to the technical specifications chart in

the Technical Information chapter of this manual.

The listed current rating indicates the maximum current draw during normal operation.

Please refer to the Sizing the Circuit Breakers section in the Appendix chapter of this

manual.

Never connect the Q-Spot 260-LED to a rheostat (variable resistor) or dimmer

circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.

AC Plug

The Q-Spot 260-LED comes with a power input cord terminated with an IEC connector

on one end an Edison plug on the other end (US market). If the power cord that came

with your fixture has no plug or you need to change the Edison plug, use the table

below to wire the new plug.

Connection Wire (US) Wire (Europe) Pin

AC Live Black Brown 1

AC Neutral White Blue 2

AC Ground Green/Yellow Green/Yellow 3

Fuse Replacement

1) With a flat head screwdriver, wedge the fuse holder out of its housing and remove

the blown fuse from the holder.

2) Replace the blown fuse with a fuse of the exact same type and rating.

3) Insert the fuse holder back in its place, and reconnect power.

Make sure to disconnect the fixture’s power cord before replacing a blown fuse,

and always replace it with a fuse of the same type and rating.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Keine Kommentare

Chauvet Q-Spot 360-LED Bedienungsanleitung Seite 9