Chauvet Q-Spot 360-LED Bedienungsanleitung PDF herunterladen (Seite 21)

Technical Information

April 7, 2010 -17- Q-Spot 260-LED User Manual Rev. 01d

Q-Spot 260-LED Troubleshooting Guide

Symptom Cause(s) Action(s)

Fixture is on

LED is off

LED connection problems Reconnect LED

Faulty LED Replace LED

Faulty LED driver Replace LED driver

Fixture is on

Head fan is off

Faulty head fan Replace head fan

Faulty LED driver Replace LED driver

Fixture is on

Base fan is off

Faulty base fan Replace base fan

Faulty power supply Replace power supply

Color wheel problem

Faulty color wheel motor Replace color wheel motor

Faulty sensor board Replace sensor board

Faulty X/Y control board Replace X/Y control board

Prism problem

Faulty prism motor Replace prism motor

Faulty prism belt Replace prism belt

Faulty X/Y control board Replace X/Y control board

Gobo wheel problem

Faulty gobo wheel motor Replace gobo wheel motor

Blocked gobo wheel Unblock

Faulty sensor board Replace sensor board

Faulty X/Y control board Replace X/Y control board

Pan movement problem

Faulty pan motor Replace pan motor

Faulty pan belt Replace pan belt

Faulty magnetic sensor Replace magnetic sensor

Faulty optical sensor Replace optical sensor

Faulty X/Y control board Replace X/Y control board

Tilt movement problem

Faulty tilt motor Replace tilt motor

Faulty tilt belt Replace tilt belt

Faulty magnetic sensor Replace magnetic sensor

Faulty optical sensor Replace optical sensor

Faulty X/Y control board Replace X/Y control board

Circuit breaker/fuse keeps

tripping/blowing

Excessive circuit load Check total load placed on the electrical circuit

Short circuit along the power wires Check for a short in the electrical wiring

Fixture does not power up

No power Check for power on power outlet

Loose or damaged power cord Check power cord

Blown fuse Replace fuse

Faulty On/Off switch Replace On/Off switch

Faulty internal power supply Replace internal power supply

Fixture does not respond

to DMX

Wrong DMX addressing Check control panel and unit addressing

Damaged DMX cables Check DMX cables

Wrong polarity on the controller Check polarity switch settings on the controller

Loose DMX cables Check cable connections

Faulty DMX interface Replace the display board

Faulty Display board Replace the display board

DMX signal problems

Non DMX cables Use only DMX compatible cables

Bouncing signals Install terminator as suggested

Long cable / low level signal

Install an optically coupled DMX splitter right after

the fixture with the strong signal

Too many fixtures

Install an optically coupled DMX splitter after unit

#32 or before

Interference from AC wires

Keep DMX cables separated from power cables or

fluorescent/black lights

If you still experience technical problems after trying the above solutions, contact

CHAUVET® Technical Support.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare