Chauvet Q-Dream Bedienungsanleitung

Q-DreamQ-Dream™ DMX Intelligent Effect Light USER MANUAL CHAUVET, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A (800) 762-1084 – (954) 929-1115 FAX (95

Operating Modes • Two stand-alone modes; Sound-active mode will listen to sound and run through its diverse range of built in programs and an

Operating Instructions DMX Mode Operating in a DMX Control mode environment gives the user the greatest flexibility when it comes to customizing or cr

Segment Display Configurations The display can be inverted making it easier to read the menu depending on the orientation of your fixture. P8

APPENDIX DMX Primer There are 512 channels in a DMX-512 connection. Channels may be assigned in any manner. A fixture capable of receiving DMX-512 wi

Appendix DMX Channel Values DEFAULT VALUE FUNCTION 1 000 Ù 000 001 Ù 127 128 Ù 187 188 Ù 193 194 Ù 255 Color None Indexed color change Color s

Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors

Appendix General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check f

Appendix Technical Specifications WEIGHT & DIMENSIONS Length...

Table of Content BEFORE YOU BEGIN...

BEFORE YOU BEGIN What is included ¾ Q-Dream™ with HTI150 bulb ¾ Power cord with plug ¾ Manual ¾ Warranty Card Unpacking Instructions Immediately up

INTRODUCTION Features Control Features • 5 channel DMX-512 3D projector • Rotating gobos - 5 interchangeable rotating gobos + open - 4 glas

Introduction Product Overview Control Board Enter Choose Up Down  i j SEGMENT BUTTONS I/O PANEL OVERVIEW BUTTONS I/O PANEL Choose Tog

SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. An HTI150 high intensity discharge lamp is included

Lamp Alignment How-To Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is referred to as

Introduction Mounting Orientation Both fixtures can sit on stage or be mounted on a truss using a clamp in any position, provided, there is ade

OPERATING INSTRUCTIONS Control Panel On the control panel you can set the DMX address, set the fixture to Master/Slave mode, reset the fixture