Chauvet S-MOVER DMX512 Bedienungsanleitung Seite 1

Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle S-MOVER Stage

Mounting ORIENTATION This fixture may be mounted in any position provided there is adequate room for ventilation. RIGGING It is important never to ob

Menu Map enu Functions DESCRIPTION MMENU OPTION DMX: The fixture will be controlled by a DMX signal coming from a DMX controller. ess must be selec

TO SET THE TILT TO INVERTING OR NON-INVERTING: 1) Press <MODE/ESC> until is dptions. isplayed. 2) Use the <UP> and <DOWN> buttons

Master/Slave Mode (Master Sound, Master Auto): This mode will allow you to link up to 32 units together without a controller. 1) Use standard DMX cab

General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check fan thermal swi

If you still have a problem after trying the above solutions, please contact CHAUVET Technical Support at the location on the next page. Technical Sup

General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing f

Technical Specifications WEIGHT & DIMENSIONS Length...

TABLE OF CONTENTS 1. BEFORE YOU BEGIN...

1. BEFORE YOU BEGIN What is included ¾ 1 x Stage Mover™ ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of

2. INTRODUCTION Features • 8-channel DMX-512 stage mover • Pan: 540° / tilt: 270° • Variable electronic dimmer (0 – 100%) • Remote fixture rese

Product Overview Yoke Control Panel Head Gel Housing & Protective Screen Carrying Handle Base Voltage Selector Swi

3. SETUP Lamp Optional 500W or 1000W lamps may be purchased from any Chauvet dealer. Warning! When replacing the lamp, please wait 15 minutes after

Fixture Linking You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run synchronized shows on

3-PIN TO 5-PIN CONVERSION CHART Note! If you use a controller with a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter. CHAUV