Chauvet Q-Spot 150-LED Bedienungsanleitung PDF herunterladen (Seite 13)

Operating Instructions

Q-Spot & Q-Spot 150 User Manual 13 2005-11-15/13:11

User Configurations

(P1-y) – 16 bit Control

In the 16 bit Control Channel mode you gain a higher degree of resolution in both Pan and Tilt

movement. One extra channel for both the Pan and the Tilt are added and they perform as the “Fine”

movement.

The primary Pan or Tilt channel is known as the MSB “Most Significant Bit”. This is the channel that

controls the course or broader range of movement. On a DMX signal stream, there are 255 values for

one channel.

The “Fine” Pan or Tilt channel is known as the LSB “Least Significant Bit”. This channel gives you

control of the space between any two MSB values. In other words, it increases the resolution of both

the Pan and Tilt movement, by providing the control of 255 additional values in between each Primary

channel value.

FUNCTION SET TO DESCRIPTION NOTES

P1 -y 16 bit Control Hi resolution mode

P2 -n 16 bit Control (Alternate)

P3 -n 8 bit Control with Speed

FUNCTION SET TO DESCRIPTION NOTES

P1 -n 8 bit Control

P2 -y 16 bit Control (Alternate)

Fine (LSB) channels are swapped.

1- Pan / 2-Pan (Fine) / 3-Tilt / 4-Tilt (Fine)

P3 -n 8 bit Control with Speed

Default (P1-n) & P3 – 8 bit Control

In 8 bit Control Channel mode Pan and Tilt are controlled using the (MSB) method only.

FUNCTION SET TO NOTES NOTES

P1 -n 8 bit Control Channel

P2 -n 16 bit Control (Alternate)

P3 -n 8 bit Control with Speed

This is the default setting for the unit

FUNCTION SET TO NOTES NOTES

P1 -n 16 bit Control Channel

P2 -n 8 bit Control Channel

P3 -y 8 bit Control with Speed Ch

Pan/Tilt (Fine) channels are removed and

Speed Control of Pan & Tilt is added (vector)

P-4 – {Function reserved and not in use}

P5 - Pan Invert / P6- Tilt Invert

It is possible to invert the pan and tilt mirror movement from within the fixture itself. This could be

helpful in situations where the positioning or rigging of a fixture led to a reverse orientation of the

fixture in relation to all or most other fixtures installed. When choosing to command the pan or tilt of

all fixtures at the same time you will notice that the fixtures whose orientation is different from the

others will most likely move opposite of the rest. You can apply a pan and tilt Invert by following the

settings in the table below.

FUNCTION SET TO NOTES

P5 -y Pan Invert

P6 -y Tilt Invert

P5 & P6 -n Return to normal

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare

Chauvet Q-Spot 150-LED Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flutlichter Chauvet Q-Spot 150-LED