Chauvet CH-330 Bedienungsanleitung PDF herunterladen (Seite 5)

CH-330 User Manual 5

2006-08-25/20:37

Lamp cover

plate

Hanging Clamp

SETUP

Lamp

You may need to install a lamp prior to the initial operation of the fixture. Two 64514 300W halogen

bi-pin lamps are included.

Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to

cool down! Always disconnect from main power prior to lamp replacement.

Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp

with alcohol and wipe it with a lint free cloth before installation.

For lamp installation in 230V environments please read “Lamp (In-Series) Wiring” in the

Appendix section of this manual.

LAMP INSTALLATION

1) Remove the (S1) screw located on top of the

fixture as shown in the image.

2) Flip open to expose lamp and socket.

3) If replacing the lamp, remove old lamp first.

4) Using a cloth or napkin hold the bulb and

pull out of the lamp socket located inside the

reflector.

5) Replace with a new lamp.

6) Flip cover to close, align the screw hole and

fasten the screw.

Mounting

ORIENTATION

This fixture may be mounted in any position provided there is adequate room for ventilation.

RIGGING

It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O”

type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding

the desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp

replacement access and routine maintenance.

• Safety cables should always be used.

• Never mount in places where the fixture will be exposed to rain, high

humidity, extreme temperature changes or restricted ventilation.

1 2 3 4 5 6 7 8 9

Keine Kommentare

Chauvet CH-330 Bedienungsanleitung Seite 5