Chauvet DMX-50A Bedienungsanleitung PDF herunterladen (Seite 5)

Introduction

DMX-50A User Manual 5

Revised: 2006-04-24 15:26:16

Product Overview (front)

Item Button or Fader Function

1 Scanner select buttons Fixture selection

2 Scanner indicator LEDS Indicates the fixtures currently selected

3 Scene select buttons Universal bump buttons representing scene location for storage and selection

4 Channel faders For adjusting DMX values, Ch 1~8 can be adjusted immediately after pressing the

respective scanner select button, Ch 9~16 after pressing the Page select button

5 Page A Indicator LED Represents Ch 1~8 range selected,

Tip! Tap A, B then B again to control both pages simultaneously.

6 Page B Indicator LED Represents Ch 9~16 range selected

7 Page select button In manual mode, press to toggle between pages of control or to select both pages

simultaneously. Both LEDS on will allow control of both lower and upper range channel.

8 Program button Used to enter programming mode

9 Music/Bank Copy button Used to activate Music mode and as the copy command during programming

10 LCD display window Status window displays pertinent operational data

11 Mode Indicator LEDS Provides operating mode status, (manual, music or auto)

12 Bank Up button Function button to traverse Scene/Steps in banks or chases

Incremental DMX values while FINE button is active.

13 Bank Down button Function button to traverse Scene/Steps in banks or chases

Decremental DMX values while FINE button is active.

14 Tap Display button This is a Tap-Sync during playback and during programming changes the DMX value

displayed in the LCD panel to percentages

15 Blackout button Sets the shutter or dimmer value of all fixtures to “0” causing all light output to cease

16 Midi/Rec button Activates MIDI external control and also used to confirm the record/save process

17 Assign LED Indicated the controller is in Channel assign mode during the initial setup of the controller

18 Auto/Del button Used to activate Auto mode and as the delete function key during programming

19 Chaser buttons Chase memory 1 ~ 6

20 Speed fader This will adjust the hold time of a scene or a step within a chase

21 Fade-Time fader Also considered a cross-fade, sets the interval time between two scenes in a chase

22 Fine button Activates 16 bit control of the joystick, movement will be in extremely small increments.

Note: While FINE is active Bank UP/DOWN buttons will increase and decrease DMX

values by one for either the joystick or the slider in focus or currently moved.

23 Pile Up / Chase LED

24 Joystick Generally used to control the pan and tilt movement of a fixture

25 Mode button

1 2 3 4 5 6 7 8 9 10 ... 23 24

Keine Kommentare

Chauvet DMX-50A Bedienungsanleitung Seite 5