Snapshot OK on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle Élan™
4. OPERATION Stand-Alone Mode (Sound-Active): This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mod
DMX Mode DMX mode allows the user to select specific colors displayed, as well as the shutter speed (for strobe effect), by adjusting the value of fou
SETTING THE STARTING ADDRESS This DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start address" fro
DMX QUICK REFERENCE CHART DMX Address Quick Reference Chart Dip Switch Position DMX DIP SWITCH SET #9 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 0=OFF #8 0 0 0
General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check fan thermal swit
Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-
General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing f
Technical Specifications WEIGHT & DIMENSIONS Length...
TABLE OF CONTENTS 1. BEFORE YOU BEGIN...
1. BEFORE YOU BEGIN What is included ¾ 1 x Élan™ ¾ Power cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fi
Safety Instructions Please read these instructions carefully, as it includes important information about the installation, usage and maintenance of
2. INTRODUCTION CONTROL FEATURES • 4-channel DMX-512 LED effect light • Blackout/static/strobe • Individual control of red, green and blue LEDs
Product Overview Hanging Bracket Control Panel Lens Mic for LED Sound Sensitivity for Knob for LED DMX In Power Connector with
3. SETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside
CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR connector on the other end. can cause a ground loop, and your fixt
OStthinitialized for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow may also require a s
Kommentare zu diesen Handbüchern